Solares™ Smart Spa Bathing System Operating Manual
CD0036
- 25 -
1121
Remedy
+™
:
UV indicator lights. Report current status of
UV Bulbs. These lights appear off when UV is
turned off and for a few seconds after it is
first started. The
™
disinfection
system will turn on automatically when the
whirlpool turns on.
Tilting:
The above image will show up in the
bottom right-hand corner of the screen
while the tub is lowing itself. (happens if
auto-tilt is enabled)
. You can press “Stop
Tilt” at any time to prevent the tub from
tilting down further.
Errors:
If “Error” is displayed at the bottom left of the
screen, then there has been a problem
detected with the system. You will need to
check the maintenance screen for a detailed
description of the problem.
Cleaning and Disinfection Menus
1.
Place the chair in the tub, release the
carrier from the tub, and close the door
before beginning cleaning.
2.
Select “Begin Automatic Clean and
Disinfection” on the touch screen to be
guided through the cleaning/ disinfecting
process.
You can select “Manual Clean and
Disinfection” to go to the cleaning,
disinfecting, or rinsing page directly.
Whirlpool Cleaning Procedure
1.
Select Begin Cleaning. The tub drain will
close and the tub will begin filling the
whirlpool plumbing with water mixed with
the correct ratio of cleaning product. The
whirlpool motor will start automatically.
Observe the flow of detergent and water
through the tub’s jets. Close off each of
the tub’s jets. Detergent should be
observed flowing from all the jets.
Summary of Contents for Solares Smart Spa
Page 30: ......
