Quick Start Guide Version 1.3
Devolinx Serial-Ethernet Server
STE-501C
Copyright © 2007 Aaxeon Technologies, LLC
All rights reserved.
2
COM Port LED
Message
Description
Off
No data is transmitting on COM port
Blinking
Data is transmitting on COM port
Table 2. COM Port LED Message
RUN LED
Message
Description
On
Jumper JP1 Pin1 and Pin2 are shorted to disable
AP firmware running
Blinking (rate: 0.5 Sec)
AP firmware is running normally
Table 3. RUN LED Message
Installation Procedures:
Step 1
: Connect the STE-501C to the power source using 5V DC Jack
(or 9~30V DC Terminal Block power source)
Note: STE-501C provides two power inputs that can be connected simultaneously to live DC
power sources. If any one of the power inputs fails, the other live source acts as a backup to
support power needs automatically. The redundant dual DC power inputs give an extra
assurance of non-stop operation
Step 2
: Connect the STE-501C to ones Ethernet network. Use a standard straight-through Ethernet
cable when one connect it to a hub/switch, one also can connect it to ones PC‘s Ethernet
port via a cross-over Ethernet cable for easy set up. However, in this case one need to
make sure ones PC is in the same network sub-net as the STE-501C.
Step 3
: Connect the STE-501C’s serial port to a serial device.
Step 4
: Placement options. One can mount the STE-501C to a wall/panel (Mounting screws included)
or Din-Rail rack (Require optional item model: Din-Rail-Kit).
3. Software Setup
Default Network Setting:
Default User Name/Password:
IP:
10.0.50.100
User Name:
admin
Gateway:
10.0.0.254
Password:
null (leave it blank)
Subnet:
255.255.0.0
Auto IP (Dynamic IP):
A DHCP server can automatically assigns the IP address and network settings. The STE-501C
supports the DHCP function. By default, the DHCP function on the STE-501C is disabled; you can
use Monitor.exe to enable this function. (ref Figure 3.1)
Figure 3.1. monitor.exe utility Dialog Window