Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
8
* Read card
Input old PIN #
Input new PIN #
Input new PIN #
* User ID
number
Input old PIN #
Input new PIN #
Input new PIN #
4.6 To change the PIN of a PIN user
Or
Remark:
For the users with card and default PIN “1234”, must read card to change the
PIN for the first time.
For users without card, must get ID number and initial new PIN from previous.
4.7 Door Bell
Press the door bell button on the access control unit, the buzzer will sound ring
back tone, at the same time, the I box's built-in door bell or the outer door bell
will ring.
5. Alarm
5.1 Anti-tamper Alarm
When the access control unit is disassembled illegally, the access control unit's
buzzer and the external alarm will operate.
5.2 Door status contact
When connect with door status contact, if the door is opened illegal, the access
control unit's buzzer and the external alarm will operate.
5.3 Anti-duress alarm
When read duress card / input 8 digits duress PIN#, the corresponding lock will
open, at the same time, the external alarm will operate, but the access control
unit's buzzer will not operate.
5.4 To remove the alarm
Read valid card or input master code can remove the alarm. If there is no opera-
tion, the alarm will remove automatically after 1 minute.
6. Keypad lockout or alarm
To prevent consecutive enter of an invalid master code, user password, or anti-
duress or invalid card, this function will be activated after 10 times consecutive
errors input. There are 3 mode available: No keypad lockout or alarm, keypad
locked for 10 minutes, alarm for 1-3 minutes.
7. To Reset to Factory Default
Power off, power on, the LED will turn in orange after 1 second, press
*
within
1 second (when LED is orange), release it until hearing two shot beep, then
hearing a long beep, enter normal mode - it means reset to factory default set-
ting is successfully.
Remark: Reset to factory default, the users' information is still retained.
