Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
13
7.1 Deleting a single user with a card or PIN
After entering the programming mode enter the code
37
, then
Enter the user ID from the list
or
Close deleting card to the reader
After you read the card controller will generate a single beep and automatically
exits the programming mode.
7.1 Removal of all users
After entering the programming mode enter code
38
.
This process can take more than 10 seconds. Then the controller will generate a
single beep and automatically exits the programming mode.
8.1 Administrator PIN code - used to enter the programming mode
After entering the programming mode enter the code
41
, then
Enter the PIN -> enter the PIN again
After adding a new administrator PIN code controller will generate a single beep
and automatically exits the programming mode.
NOTE: The default master code 000000 is mandatory to change after the
first entry into this mode on your own code using the command 41.
Leaving the default code allows third parties to enter into this mode and
operations, e.g. adding his own card. If you do not know the master
code reset can be performed from within the program KaDe - context
menu: Controller / Restore Defaults. The password can be also upload to
all controllers (Controller Setup).
8.2 PIN code security
After entering the programming mode enter the code
42
, then
Enter the PIN -> enter the PIN again
After adding a PIN controller generates a single beep and automatically exits the
programming mode. This code can be used in the event of a forced entry - the
doors are unlocked mode and alarm signal is sent to the on-line monitoring at
the operator station.
