5
According to USB compatibility, a high-quality cell phone charger (do not use
low-quality cell phone charger), or plug it into a computer's USB port to
charge the equipment.
When charging, the battery LED indicator
will blink green and the ON
power LED indicator
will blink red. When the charge is full,
approximately 4~5 hours, the
indicator will stay lit. The Lithium
battery contains a chip that is used to provide protection and prevent over
charging and over-discharging.
Operation
..
(A)
On / Off Switch
To turn on the unit, please slide the power switch up. The power
LED will light up in red, indicating that the monitor is on.
To turn off the unit, slide the power switch down.
(B)
Access to Audio and Video
To access audio functions, plug a 3.5mm audio cable on the side of
the monitor device (above the power switch) then connect the end
directly to the camera.
This unit has a built in amplifier and speaker, so it can be directly
connected to any other audio feed.
When using audio only, the unit will enter SLEEP STATE after 3
minutes reducing energy consumption. Accessing video, simply by
plugging in the video cable can automatically wake the unit up on to
normal ON Mode.
Power
..
(A)
12V DC Power Supply Output to Camera:
To supply power to camera, insert the included power switch wire
into 12V DCOUT (between the USB and audio input) then to the input
device. Once the connection has been made the “12V DC” indicator
light will turn on.
NOTE:
The maximum output current is 12V DC 200mA. The output has
over-current, over voltage and short circuit protection functions.
Do not use high
power IR cameras because it will overload and damage the power module.