PROGRAMMING
A person desiring a access to the program mode will enter the present MASTER CODE. If the master code is
valid a GOODBEEP will be heard prompting the person to enter a number corresponding to the SUB-MODE,
eg. (MASTER CODE) then (Number corrresponding to Sub-Mode)
. Once in the program mode the individual
will have approximately 15 seconds between keypresses or the unit will sound an ERRORBEEP and exit the
program mode.
NOTE: An access code log sheet is provided on page 8 which can be photo-copied. A
good source for access codes is the phone book or the last 4 digits of social security numbers.
SUB-MODES
“1”
Sub-Mode 1 (Enter New Access Codes)
To enter new access codes enter the MASTER CODE, followed by 1, then enter each new ACCESS CODE you
wish to program into the unit.
(MASTER CODE) then 1 then (ACCESS CODE) then (ACCESS CODE) etc... (# to exit)
Should you make an entry error, simply press the * key and re-enter the correct data. You may continue
entering access codes until the memory is full or the # is pressed. You may select any 4 digit access code that
is not already in use by the system. The unit will respond with a GOODBEEP with the acceptance of each new
access code. If you do not receive a GOODBEEP after the entry of an access code, you must select a new
access code as it is already in use by the system. When the memory becomes filled, you will receive a
GOODBEEP indicating the acceptance of the last access code entered and then the unit will sound an
ERRORBEEP and automatically exit you from the program mode.
NOTE: You will not be able to enter this
mode if memory is full and will receive an ERRORBEEP.
“2”
Sub-Mode 2 (Delete Access Codes)
To delete any access code from memory enter the MASTER CODE, followed by 2, and then each access code
to be deleted
(MASTER CODE) then 2 then (CODE TO BE DELETED) then (NEXT CODE TO BE DELETED) etc... (# to
Exit)
Should you make an entry error, simply press the * key and re-enter the correct data. You may continue
deleting access codes in a successive manner. The unit will respond with a GOODBEEP with the successful
deletion of each access code. If you do not receive a GOODBEEP the access code entered could not be found
in memory and the unit will wait for you to enter another code to be deleted.
“3”
Sub-Mode 3 (Change Master Code)
To change the master code enter the PRESENT MASTER CODE, followed by 3, and then the NEW MASTER
CODE.
(PRESENT MASTER CODE) then 3 then (NEW MASTER CODE)
Should you make an entry error, simply press the * key and re-enter the correct data. You may select any 4 digit
code as your new master code that is not already in use by the system. The unit will respond with a
GOODBEEP upon acceptance of the new master code and automatically exit from the program mode. If the
unit does not respond with a GOODBEEP, you must select a different code as it is already in use by the system.
6
