SPECIFICATIONS
Model SW-200
20Hz - 150Hz Adjustable
150 watts
0.05%
- High 200 ohms - Low 45K ohms
- High 1V - Low 50mV
Bass Reflex
1 x 265 mm
460mmH x 315mmW x 445mmD
23 Kgs
NOTE: This model has passed the C-Tick compliance
requirements, our supplier code is N1136.
Periodically wipe the cabinets with a damp cloth using a mild detergent or you may use a polish
such as Mr Sheen. Vacuum the grill cloth and cooling fins with the brush attachment of the vacuum
cleaner from time to time. Remove the grill and lightly dust the speaker diaphragms with a clean
paint brush. Every 2 years rotate the Woofers one screw hole.
OPERATION
CARING FOR YOUR SUBWOOFER
1. Connect all leads making sure that all are in their correct position.
2. Make sure that no music is coming from your stereo.
3. Set the Volume control (8) to the 9 o'clock position.
4. Set the Frequency control (11) to the 12 o'clock position.
5. Switch the power switch (3) on.
6. Play some music from your stereo amplifier and turn the volume up slowly.
7. If everything seems fine, proceed to adjust your subwoofer so the sound is most pleasing to
your ears.
8. Should you encounter any problems seek advice from the dealer who supplied you the
appliance.
concerned if the difference is very small, that is quite often the case.
10: Crossover By-Pass Switch
This switch eliminates all filter circuitry from 20Hz up. This switch can be activated where the
amplifier used, has it`s own built-in channel filter circuitry.
11:Frequency Crossover Control
By turning the knob clockwise, the crossover frequency is increased, so by doing this you are
allowing the subwoofer to reproduce more of the upper bass. If, for instance, you have main
speakers that already have reasonable bass, then you adjust the control in an anti-clockwise
direction. On the other hand, if you are using satellite speakers, then the control should be
set around mid position. The best way to use this control is setting it to your own personal
taste.
12:Cooling Fins (Heat Sink)
At no time should anything be placed too close to these fins. Their function is to cool the
amplifier and if cooling is restricted, damage may occur to the amplifier and this is not
covered by warranty. Don`t be alarmed if they are hot to touch during operation as this is
quite normal.
CONTROL FUNCTION AND FEATURES Continued...
Specifications:
Frequency Range
Output Power
Distortion
Input Impedance
Input Sensitivity
Bass Alignment
Woofers
Dimensions
Weight
