AAQ AL-6214A, Installation, Operation, And Parts Manual

Page: 9 / 32

8
Installation, Operation and Parts Manual
AutoLift AL-6214
POWER SIDE POST OTHER POST
Step 11: Install lifting arms.
Install the lifting arms on the carriage by 38mm pins. NOTE: Long arms are to the rear of the vehicle.
Step 12: Fill oil tank.
Oil tank volumn is 10L. Normal work should have 80% oil inside the tank.
Usually the hoist needs 13 litres of hydraulic oil. Fill about 10 litres into the oil tank then run the hoist up and down 2 or 3 times.
Refill the remainder 3 litres of oil. It is suggested to use 32#anti-abrasion hydraulic oil.
Step 13: Locking Mechanism.
Do refer to the operation instructions in advance and keep in mind that NO vehicle is to be placed on the hoist during
trial run.
1. Route lock cable and conduit from motor post up to top of column, then over to the next column, then down to the lock assembly.
2. Loop the lock release cable over the pull handle latch bolt, then lock off with barrel union. Apply tension to lock cable on opposite
post lock latch bracket, then lock off with barrel union.
3.
Check mechanical locks for correct engagement by releasing the lock handle during the running process. Adjust by tightening
the wire cable on the lock latch if needed. NOTE: Hoist must be rested on locks during adjustments.
Step 14: Connect Power and do a trial run.
1. Assure all the connections are in good condition and connect the power supply.
Step 15: Fix feet protection fenders, door-opening protections, tool trays and lock covers.
3.4 Items to be checked after installation.
S/N Check items YES NO
1 Are the posts vertical to the floor?
2 Are the two posts paralleled?
3 Is the oil hose well connected?
4 Is the steel cable well connected?
5 Are all lifting arms well fixed?
6 Are electrical connections right?
7 Are the rest joints firmly screwed?
8 Are all items need lubricating added with grease?