A&E Systems
ELECTROLUX AW
ELECTROLUX AW AWNING
INSTALLATION / OPERATION
Application:
The Electrol
ux AW Case Awning is designed and intended for
direct mounting on straight and most curved mini-motor-
homes, pick-up campers, vans, van conversions and pop-up
tent trailers.
The optional Universal Van Adapter
Kit A&E
Part No. 939935
allows permanent or temporary mounting to vans with rain
gutters without drilling holes in the van.
IMPORTANT: Read the entire installation procedure
before starting installation.
NOTE:
The manufacturer assumes no liability for
damages or injuries resulting from installation or
operation of this product.
The manufacturer reserves the right to modify appearanc-
es and specifications without notice.
INSTALLATION
Tools Required:
Measuring Tape
Pencil
Electric Drill
Knife or Equivalent
Drill Bits: 3/16”(15mm);
Pop Rivet Gun
1/8”(3mm)
Necessary
only if Backing late is
q
Center Punch needed)
Phillips Screw Driver
Silicone Sealant
FOR DIRECT WALL MOUNTING:
NOTE: When determining location for awning make
sure to consider door clearance if required and location
of vehicle components, etc.
SHEET METAL
SCREW
1B
1 0 x 3/4 PHILLIPS P
A
N H E A
SHEET METAL SCREW
1. A.
0.
Install C-Channel of awning Case into Awning Rail
by inserting C-Channel into one end of Awning Rail
and sliding awning Case into position (Fig. 1 A),
or
by tilting Case up and inserting entire C-Channel
into Awning Rail and rotating Case down into posi-
tion. Fig. 1B.
Using the End Caps as templates, drill one 1/8" Dia.
hole into vehicle for each End Cap. Fig. 1A.
Secure each End Cap using one #10 x 3/4" Phillips
Pan Head Sheet Metal Screw with a small dab of
Silicone Sealant on each screw. Figs. 1A & 1 B.
NOTE: Be sure to use a dab of Silicone Sealant on every
screw where a hole has been drilled in the side of the
vehicle. This will prevent possible water leakage.
AWNING CASE
2. Using Wand, open awning Case by inserting Pin on end
of Wand into hole in Arm Assembly indicated by arrows
on bottom of Case. Fig. 2.
3. Lower Arm Assembly out of awning Case. Fig. 3.
4. A. Allow arm to hang freely from Case. Tighten Lock
Knob. Fig. 4A.
Repeat for other side.
4C
SIDE VIEW
B.
Lower Arm Assembly to ground. With Foot still on
ground raise
Inner
Arm as high as it will go, Fig. 4B.
2
