A&D SJ-3000WP-BT, Instruction Manual

Page: 6 / 48

4
3.
PREPARATION
3.1. Installing / Exchanging Batteries
The batteries are not included with the product. Prepare 6 x "D" size (R20P or LR20) dry-cell
batteries.
When
the mark is displayed, exchange the old batteries with new ones.
1. Loosen the screws for securing the
battery cover using the provided
screwdriver, and remove the battery
cover.
2. Remove all the old batteries from the
battery compartment.
3. Install six new batteries properly
according to the + and - indicators of
polarity in the battery compartment.
4. Close the battery cover, and tighten the
screws for securing the battery cover.
CAUTION
 Do not mix used and new batteries. Do not mix the different types of batteries.
That may cause damage to the batteries or the scale.
 Take care of the polarity of batteries. The polarity marks are shown in the
battery compartment.
3.2. Setting Up The Scale
CAUTION
 Avoid installing the scale in direct sunlight, that may cause discoloration or
malfunctions. Place your SJ-WP/-BT on a firm weighing table so that the scale
is level. The scale will not perform accurately when it is not level.
 Place the scale on a firm surface and adjust the feet
so that the bubble of the sprit level is in the center
of the circle.
OK NG
(R20P/ LR20
/ D size)
Six new
batteries
Battery
cover
Screw for securing
cover
Old
batteries