Operators and Maintenance Manual
Display
EEM MOT 01 FE01.07
Page
8/16
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: [email protected]
■
www.aatech.pl
4. Operation and maintenance
The display is to be connected to EMS DAQ R2.
The front panel of EEM MOT 01 is composed of three elements: the
display, two status diodes (alert indication), and the encoder knob & push-
button for setting parameters (Fig. 5).
Rys. 5.
Front panel of EEM MOT 01 Display
The EEM MOT 01 display displays values of flight parameters that are
either directly measured or calculated by the system. The display starts
automatically as the power is turned on.
As shown in Figure 6, the monitor with FE01.07 software version presents:
a)
Engine speed
–
in the upper of the display;
b)
Cylinder head temperature
–
in the middle of the display; its
right bar graph shows the temperature of the right side of the
cylinder head, and the left bar graph
–
the temperature on
the left of cylinder head;
c)
Exhaust gas temperature
–
in the bottom of the display; its
right bar graph shows the temperature measured of the right
side of the engine, and the left bar graph
–
the temperature
on the left.
