Page 6
Page 7
Pacific Accessory Corporation
®
| 866-931-8021 | [email protected]
©2016 Pacific Accessory Corporation
www.pac-audio.com
Rev. 061716
Pacific Accessory Corporation
PAC is an AAMP brand
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
USB and AUX cable Installation
1. Use a flat bladed plastic trim tool and release the retainer clips
securing the console’s (1) right & (2) left side covers to the front
floor console assembly.
2. Move the front seats to the forward most position.
3. Remove the 4 Phillips head bolts (3) securing the consoles rear
cover (4) to the front floor console.
4. Remove the front floor console rear cover (4).
5
. Remove the electrical connections from the back of the AUX and
USB panel located inside the center console.
6. Connect the RPK5-GM4101-AUX-HAR and the RPK5-GM4101-
USB-HAR (if the vehicle is equipped with factory AUX).
7. Route the new AUX and USB cables down the driver side and
using a fish tape, route the cables up into the radio cavity.
Sub-Dash Preparation
1. Locate the radio brain alignment tabs. Each
side needs to be trimmed for clearance of the new
HVAC panel
2.
Remove the conical portion of the
alignment tab.
3.
When finished, the tabs should look like the
one below.
Kit Assembly Instructions (Single DIN)
Single DIN Mount Applications
1. Snap and lock each of the side brackets onto the pocket. FIG 1
2. Insert ISO mountable radio between the side mount brackets and loosely attach to
sides of radio using screws provided with radio when possible or hardware included
with kit.
3. Slide radio component forward or backward for desired look and tighten screws.
4. Attach a rear support bracket to the rear of the new radio and adjust as necessary to
attach to the rear support stud located on the back of the pocket using the small
phillips screw supplied with kit (optional).
5. Insert kit and radio into dash. Line up with the factory mounting point. Secure to the
dash using the factory 7mm bolts.
FIG 1
1. Locate the factory radio module mounting hole
towards the back of the dash opening.
2.
Cut and remove the portion that extends
towards the front dash opening.
Note: Some radios will require extra
depth during installation. If you
encounter this issue please follow the
next two steps to modify the dash for
extra clearance.
***Warning: Check for factory wiring
harnesses around (including behind)
this area before cutting. Use caution
not to cut any of this wiring
