SBC-657
2 0
SBC-657 User's Manual
9/596
Connecting the floppy drive
1. Plug the 34-pin flat-cable connector into CN4. Make sure that
the red or blue wire corresponds to pin 1 on the connector.
2. Attach the appropriate connector on the other end of the cable
to the floppy drive(s). You can use only one connector in the
set. The set on the end (after the twist in the cable) connects to
A: drive. The set in the middle connects to B: drive.
3. If you are connecting a 5.25" floppy drive, line up the slot in the
printed circuit board with the blocked-off part of the cable
connector.
If you are connecting a 3.5" floppy drive, you may have trouble
determining which pin is pin number 1. Look for a number
printed on the circuit board indicating pin number 1. Also,
the connector on the floppy drive connector may have a slot.
When the slot is up, pin number 1 should be on the right.
Check the documentation that came with the drive for more
information.
If you desire, connect the B: drive to the connectors in the
middle of the cable as described above.
Floppy Drive Connector (CN4)
With support of different types of floppy, you can simply adopt any
of the combinations of 5.25" (360 KB and 1.2 MB) and/or 3.5" (720
KB, 1.44 MB, and 2.88 MB) drives onto the mainboard.
A 34-pin daisy-chain drive connector cable is required for a dual-
drive system. On one end of the cable is a 34-pin flat-cable connec-
tor. On the other end are two sets of floppy disk drive connectors.
Each set consists of a 34-pin flat-cable connector (usually used for
3.5" drives) and a printed-circuit board connector (usually used for
5.25" drives).
Wire number 1 on the cable is normally red or blue, and the other
wires are usually gray.
Summary of Contents for SBC-657
