Chapter 2 Installation 17
Display connectors (CN6, CN7)
The PCM-4335 PCI SVGA interface can drive conventional CRT
displays and is capable of driving a wide range of flat panel
displays, including electroluminescent (EL), gas plasma, passive
LCD, and active LCD displays. The card has two connectors to
support these displays, one for standard CRT VGA monitors and
one for flat panel displays.
VGA display connector (CN6)
CN6 is a 16-pin, dual-in-line header used for conventional CRT
displays. A simple one-to-one adapter can be used to match CN6
to a standard 15-pin D-SUB connector commonly used for VGA.
VGA display connector (CN6)
Pin
Signal
Pin Signal
1
RED
9
SIGNAL GND
2
N/C
10
H-SYNC
3
GREEN
11
CHASSIS GND
4
SIGNAL GND
12
V-SYNC
5
BLUE
13
CHASSIS GND
6
N/C
14
N/C
7
N/C
15
CHASSIS GND
8
N/C
16
N/C
When the PCM-4335's power is applied, the control signal is low
until just after the relevant flat panel signals are present.
Configuration of the VGA interface is done completely via the
software utility. You don't have to set any jumpers.
