Aaeon IMBM-H61A, Manual

Page: 27 / 52

2-19
Chapter 2: Motherboard information
5. Intel
®
H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~3)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical
drives via Serial ATA 3.0 Gb/s signal cables.
NOTES:
• You must install Windows
®
XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
• Due to H61 Chipset limitation, AHCI Mode only works on Windows
®
Vista/
Windows
®
7. Please use IDE Mode on Windows
®
XP.
• To configure the SATA type in BIOS, click Advanced tab > SATA
Configuration > SATA Mode Selection . See section 3.4.3 SATA
Configuration for details.
• When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.4.3 SATA Configuration for details.
SATA3G_3
GND RSATA_RXP3 RSATA_RXN3 GND RSATA_TXN3 RSATA_TXP3 GND
SATA3G_1
GND RSATA_RXP1 RSATA_RXN1 GND RSATA_TXN1 RSATA_TXP1 GND
SATA3G_2
GND RSATA_RXP2 RSATA_RXN2 GND RSATA_TXN2 RSATA_TXP2 GND
IMBM-H61A
IMBM-H61A Intel ® SATA 3.0Gb/s connectors
6. LVDS connector (30-pin LVDS)
This connector is for a LCD monitor that supports Low-voltage differential
signaling (LVDS) interface.
IMBM-H61A
IMBM-H61A LVDS connector
LVDS
PIN 1
Backlight Control for DC mode
GND
LV
GND
L L L L
EDID_CLK
L L L L
GND
LV
LVDS Panel Enable LVDS VCC LVDS0_CLK- LVDS VCC LVDS0_D0- LVDS0_D1- LVDS0_D2- LVDS0_D3- EDID_Data LVDS1_D0- LVDS1_D1- LVDS1_D2- LVDS1_D3- LVDS VCC LVDS1_CLK-