I
NSTALLATION DIAGRAM
S
TEP 2
S
TEP 1
D
epending on your cab model, you will have to identify which hardware you will have to use for the upper mounts on
the underside of the body. There will either be existing 8mm threaded holes for the Hex Head Bolts M8 or open slots
for the Nut-Clips M8 and Hex Head Bolts M8.
If your model existing 8mm threaded holes, Installation method as shown in Figure 4. Loosely tighten.
Once the step is aligned properly, tighten all hardware starting with the M8 bolts in the pinch weld and
then the hardware on the underside upper mount. Repeat Steps1-2 for other side.
C
arefully raise step up to the pinch weld of the body and align brackets with the mounting holes of vehicle. Install
the
Hex Head Bolts M8
, Spring Washers M8 and Washers M8(See FIG2). Loosely tighten at this time. Note: Some
models may require the drilling out of additional mounting holes in each bracket.
If your model requires the Nut clips M10, Installation method as shown in Figure 6. Loosely tighten.
F
IGURE 3
Pre-Existed Factory hole
FIGURE 5
N
ut-Clip M10
F
IGURE 2
Washer M8
&
Spring Washer M8
&
Hex Head Bolt M8
Hex Nut (M8)
Inner of pinch weld
Outside of pinch weld
F
IGURE 1
F
IGURE 4
Hex Head Bolt M8
&
Spring Washer M8
&
Washer M8
Bracket of Step Rail
F
IGURE 6
Hex Head Bolt M10
&
Spring Washer M10
&
Washer M10
Bracket of Step Rail
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806- 3972 / 626-332-4245
