I
NSTALLATION DIAGRAM
Reference picture of bracket positions for later steps. All brackets cradle should be facing toward the rear of the vehicle.
Locate existing mounting holes located on the interior wall of rocker panel.these mounting holes will be used per
the following instruction.
A
. If specified holes in the wall of the rocker panel are not threaded, remove
plastic plug and insert u-clip. ( See Fig1,2 )
B. If threaded holes are Pre-Existed
(no clip is needed) ( See Fig 3 )
Install
Step Rail
to side panel.
S
TEP 1
S
TEP 2
S
TEP 3
Bracket Cradle Facing Rearward
of vehicle
F
IG 1
DRIVER SIDE
REMOVE
F
IG 2
F
IG 3
INSERT
Pre-Existed Factory hole
A. Installation Direction of Front and Middle of vehicle
( NO threaded hole & Threaded holes are Pre-Existed )
B. Installation Direction of Rear of vehicle.
Hex Nut
&
Washer M10
&
Spring Washer M10
Hex Nut
&
Washer M10
&
Spring Washer M10
Hex Head Bolt M8
&
Spring Washer M8
&
Washer M8
Nut-Clip M8
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806- 3972 / 626-332-4245
