W
ARNING!
P
RODUCT DESCRIPTION
Read, understand and follow all warnings and instructions before using this product. Failure to follow these directions
may result in property damage, serious bodily injury, and/or death. AA Products Inc. is not responsible for any property
damage, personal injury, or death occurred while using any AA-Racks products. Retain these instructions for future
reference.
Any modification or unintended use of this product voids any warranty and could create a hazardous condition.
Loads must be secure according to local height and deification regulations and or laws.
Secured loads and connections must be re-checked periodically for tightness.
In order to prevent installation problems, any consultation or use of certified installer or installation service company
is recommended.
Model Number: P-APX25-E ( BLK & WHT )
Adjustable Side bar + Over Cab. Extension for Basic Two-bar Truck Rack
I
NSTALLATION INSTRUCTION
1. Slide 2 of the Tie Downs(D) ( one for each side ) into the Cross-Bar’ s(B) slot with 2 T-Bolts ( M8 * 25 ) (H) follow-by;
connect with washers(M) & Spring washers(L) & Plastic Adjust-Knobs(E). ( Installation of the ladder stoppers is optional for
customers’ personal preference ). ( See STEP 1 ).
2. Slide 4 of the T-Slot Nuts(G) ( two for each side ) into the Cross-bar’ s slot . Install the Cab Exts(A) onto the Cross-Bar
(B), align both side-holes then connect the Cab Exts and T-Slot Nuts, put two Bolts M8*15(I) through, screw the bolts with
Washers(M) ( See STEP 2 ).
3. Installing the Sealing Strip(C): Insert the Sealing Strip into the Cross-Bar channel to reduce wind-noise. Cut the right
length as needed. Seal the Cross-Bar with two Tubular-Caps(F). ( See STEP 3 ). Use a ladder or any assistance tools, put
the assembled rack set onto the vehicle’ s roof. Be careful!
4. Take off Tubular-Caps on both sides of the APX25, then slide 4 of the T-Slot Nuts ( two for each side ) into the
Cross-bar’ s slot. Install the P-APX25-E onto the APX25. Align both side-holes then connect Upper fastening buckle(N) &
Cab Exts(A) & Lower fastening buckle(O) with Bolt M8 * 20(J) and Washer(M) , Lock the Bolt M8 * 20(J) into the T-Slot Nuts
(G). Connect the rear of the Upper fastening buckle(N) & Lower fastening buckle(O) with Bolt M8 * 25(K) on both sides .
Tighten all the bolts, washers & nuts for the Cab Ext. and half brackets when all the adjustments are done. ( See STEP 4 ).
The P-APX25-E Series is the upgraded Truck Rack commonly known as the Over-cab style truck ladder rack with side
bars. Our design concept is an Extension-Bar Package built on a Two-barred basic truck rack style, which can be seen
commonly in the e-commerce truck rack market. The Cantilever mounts to the crossbars and provides 38" additional
inches of protection for your cab. The genius of this system is that it still allows for all of the flexibility of the Sliding
Cantilever System while protecting your cab from potentially unstable loads. Most ideally, it is guaranteed compatible with
our Model APX25.
I
NSTRUCTION MANUAL
AAPRODUCTS INC.
F
or Technical Support Call:1-888-806- 3972 / 626-332-4245