3
Setting Up the Keyboard or Wireless Desktop
1.
Make sure that your computer is turned off.
2.
Connecting the Receiver’s Keyboard Cable:
(a)
When connecting to an IBM AT keyboard port, use the 5-pin DIN connector already attached to the
keyboard cable.
(b)
When connecting to a PS/2-style, 6-pin DIN keyboard port, remove the AT adapter.
(c)
Connect the receiver’s purple keyboard cable to the computer’s keyboard port.
3.
Place the receiver eight inches (20 centimeters) from any
electromechanical device.
Installing the Keyboard Software-
iKeyWorksOffice
Before you can take advantage of the many features your keyboard offers, you
must install the driver. The driver is in the installation diskette that came
packaged with your mouse and keyboard
Windows 95/98/Me/2000/NT4.0 installation
Insert the installation diskette into your floppy disk drive.
Click the Start button and then click Run.
In the
Run
dialog window, type
A:\setup
, where “A” is the letter of your floppy disk drive.
Click
OK
and follow the instructions on your screen to complete the installation.
Selecting the Frequency Channel
The Wireless keyboard operates on two frequency channels.. Refer to the following to change the
frequency channel for your keyboard: Set the frequency channel on the receiver to
1
or
2.
Set the
frequency channel on the keyboard to
1
or
2.
The Wireless keyboard ID code
Each keyboard is assigned a unique ID code at manufacture, so the
receiver only picks up the signal from your mouse and prevents other Wireless keyboard radio signals from
operating on your computer. This feature can also be disabled, allowing other Wireless pointing devices to
operate your computer.
