Press “TUNE” Button to obtain frequency for best performance.
(For 1st Time Use or Whenever the Battery Free Mouse is
relocated to another computer.)
When to Press the “TUNE” Button?
If your mouse cursor does not move, not moving smoothly, or when the PWR
LED (red) blinks, press the “TUNE” Button until the frequency has been
adjusted for the best performance, repeat the process if needed.
How to Connect the Mouse Pad & Mouse?
1. Connect the mouse pad's USB cable to your computer USB port.
2. Place the mouse on the center of the mouse pad, and Do Not move the
mouse. The PWR LED light should now remain lit.
3. Press the “TUNE” button.
4. PWR LED turns “Off” and the RUN LED light starts “Blinking”.
5. When the Tuning Process is complete, the PWR and RUN LED will return
to their original mode.
Note:
This mouse will not work the best or
properly on a surface with steel
element. For maximum result of
using this device, we recommend
using the mouse 20mm-50mm above
such surface. A book underneath
will resolve the situation.
20-50mm
Installing the iZoomWorks Software
If there’re other mouse drivers installed on your computer, please have them
uninstalled before you start the installation process. Also please be sure you
have completed above hardware setup.
Windows 95/98/ME/2000/XP/NT4.0 installation (Note: the USB Device does
not support Windows 95/NT4.0)
Note:
1. Do not use this product on any
metal
table or surface.
The metal surface
may interface with the cross induction
frequency and have an adverse effect
on the mouse operation.
2. Do not place the product too close to
CRT monitor. Keep a distance of at
least 20cm.
3. Keep working temperature at
0 to 50 degree Celsius (0
°
– 50
°
C)
4. Frequency: 121 KHz-128 KHz
Do not place the
mouse pad too
close to CRT
monitor, keep a
distance of 20 cm.
1.
Connect the mouse-pad to your computer.
2.
Insert the installation diskette into your floppy disk drive.
3.
Select Battery Free Internet 5K Model
4.
Click the Start button and then click Install Driver Run.
5.
In the Run dialog window, type A:\setup, where “A” is the letter of your
floppy disk drive.
Click OK and follow the instructions on your screen to complete the
installation.
