THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
●
Reorient of relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65. The equipment has very low levels of RF energy that it is deemed to comply without testing of specific absorption ratio (SAR).
Hardware Installation
1. Pull out the Nano-Receiver from the bottom of mouse.
2. Plug Nano-receiver into USB port of your computer or
notebook.
3. Insert the supplied batteries, making sure that the positive (+) and negative (-) ends of the battery match the polarity indicators inside the
battery housing of the keybaord and mouse and power will be automatically on. Now you can use the keybaord and mouse.
Power Management of the Mouse
1. To turn on the mouse, switch the power button to “ON” position.
2. To turn off the mouse power, switch the power button to
“OFF“ position.
Note: The mouse can be awaked easily by moving the mouse randomly
if long time no using.
The wireless keyboard and mouse are plug-and-play. No driver is required. If you would like to get more function, please install the software
(enclosed on the CD) first.
Software Installation
1. Before installing the mouse software, please uninstall any previously installed mouse software.
2.
Insert enclosed CD to start installation.
3. Follow on-screen instructions to complete the installation.
4. The icon
will appear on your desktop, then you have successfully installed the software.
5. To launch the software, double click the icon
on your desktop or go to Start—Programs—
A4tech 8-in-Right
, then the icon
will appear in the taskbar at the right corner of your screen.
