A2Z Ozone MP-3000, Operating Manual

Page: 10 / 17

9
To turn the unit off:
• For Ambient Air:
• Turn off the ozone switch.
• Wait 10 seconds before continuing.
• Turn off the air compressor switch.
• For Oxygen Air:
• Turn off the ozone switch.
• Wait 10 seconds before continuing.
• Turn off the oxygen source.
Tube Connection and Start Up
An oxygen tank or oxygen generator can be used.
Using Oxygen Bottle/Tank:
• Connect oxygen bottle/tank to ozone generator (Oxygen In Port).
• Connect MP-3000 (110V) Ozone Generator (Ozone Out Port) to venturi injector.
• Install a check valve 10 inches after ozone outlet tube fitting. This can be done by cutting
the tube ten inches after ozone outlet fitting.
• Connect both ends of cut tubes to the check valve. Please direct the arrow on the check
valve toward venturi injector.
• Set tank gas flow meter at 2-4 liters per minute and 5 PSI maximum.
• First, open the oxygen valve. Then turn on the main ozone power switch on the front panel
of the MP-3000. The internal air compressor switch stays OFF. The ozone light and fan
should turn on.
• Increase power to the cells by turning the ozone concentration knob clockwise. Please
remember to make a full rotation clockwise.
• Prior to shutting off the feed gas to the unit, turn off the switch and allow the unit to purge
for about 1 minute. Then, turn the flow of oxygen gas off.
NOTE: Do not turn the air pump switch ON when using an oxygen generator, oxygen bottle or
tank.
Using Oxygen Generator:
• Connect oxygen generator (Oxygen Out Port) to ozone generator (
O
2
In Port).
• Connect MP-3000 (110V) Ozone Generator’s (Ozone Out Port) to the venturi injector.
• Install a check valve 10 inches after ozone outlet tube fitting. This can be done by cutting
a tube ten inches after ozone outlet fitting.
• Connect both ends of cut tubes to the check valve.