10
page
3.8 Seat height adjustment
The seat height may require adjustment. Ask your
A2B dealer to adjust it before you ride, however
to adjust the seat yourself follow these instruc-
tions:
To determine the correct height of the seat
for the rider
1. Straddle the assembled A2B with your feet
shoulder-width apart and flat on the ground.
2. There must be at least 25 mm/1 inch clearance
between the frame height (1) and the inside leg
measurement of the rider (2).
Height adjustment
1.
Release the seat post quick release by rota-
ting the quick release lever away from the seat
post until it is fully open.
2.
Adjust the saddle height accordingly to your
request. DO NOT raise the seat beyond the ‘mini-
mum insertion’ mark on the seat post.
3.
Firmly grip the seat tube with your hand, and
push the lever over to the closed position towards
the frame, ensuring that it does not protrude so
as to cause injury to the rider. The lever is secu-
rely tightened when it takes a significant amount
of force to position it in the closed position. The
appropriate amount of force necessary to close
the lever when it is properly adjusted will result in
an imprint of the lever in the palm of your hand.
When properly closed, it is impossible to move
unless you open it again by reversing the steps
above. If you can easily move it, open the quick
release lever and tighten the adjusting nut another
180º and try again.
4.
After adjustment, ensure there is no move-
ment in the seat position in any direction.
Failure to correctly secure the seat can result
in serious or fatal injury.
Ensure the seat clamp bolt (seat pillar - seat post)
is tightened to 27 Nm.
Frame height
Frame height
Inside leg height
HY
BRID
HY
BRID
Rahmenhöhe
Rahmenhöhe
Innenbeinhöhe
Frame height
1 inch / 2,5 cm
clearance
Inside leg height
1
1
2
Summary of Contents for A2B Galvani
