![background image](http://html1.mh-extra.com/html/a1tech/jazz/jazz_owners-manual_3149457024.webp)
-
-
22
-
-
Code Programming
When installing JAZZ into your vehicle, be sure to code program according to the
below mentioned procedure. And if you want to use another Remote Control
additionally, use new one after coding it by same procedure. You can use up to 3
different Remote Controls.
1. Open the door of driver
’
s seat and insert the key into ignition position.
2. Repeat ACC/ON 7 times -- chirp sounds after 2 seconds.
- Chirp sound emits a number of times to indicate the number of Remote Controls
programmed into the system.
3. Within 5 seconds, press II on each new Remote Control with one chirp sound.
Technical Support
System Initializing
If you lose a Remote Control, your vehicle may be stolen by someone else who
finds it.
In this case, you should remove the current code from JAZZ system program, and
then program new code into new Remote Control.
And if you have an error in setting the program, System Initialization is also
necessary. After initializing system, you should repeat program code into the
Remote Control and set the program again.
1. Open the door of driver
’
s seat and insert the key into ignition position.
2. Repeat ACC/ON 10 times
- Three chirp sounds after 2 seconds, confirming that the system shall be initializing.
3. Within 5 seconds, press II on new Remote Control.
ACC/ON 7 time
Press
Ⅱ
Ⅱ
ACC/ON 10 time
Press
Ⅱ
Ⅱ
Open door
Chirps
Open door
Three Chirps