page 31 |
Document No.: TH-930-001 - 1/26/2015
Sliding Rail Kit Installation
This chapter contains instructions for installing the sliding rail kit for your ACOS device.
The following topics are covered:
•
•
Getting Started
This section contains the following topics:
•
•
Rail Kit Contents
The rail kit contains the following items. Please verify that all parts are included and are not damaged.
•
2 x adjustable rail assemblies
•
12 x black 4-mm flat-head screws, for attaching the inner rails to the chassis
•
13 x silver M5-thread 7-mm flat-head screws with washers, for attaching the outer rails to the rack.
12 are required and the 13
th
is a spare.
NOTE:
Each rail assembly consists of an outer rail, a middle rail, and a removable inner rail.
Required Tools
To install the rail kit, you will need the following tools:
•
Anti-static wrist strap and conductive foam pad (recommended)
•
#1 Phillips-head screwdriver
•
#2 Phillips-head screwdriver
•
Hex nut driver
Summary of Contents for Thunder series 930
Page 1: ...INSTALLATION GUIDE A10 Thunder Series 930 ADC 26 January 2015...
Page 8: ...A10 Thunder Series 930 Installation Guide Document No TH 930 001 1 26 2015 page 8...
Page 14: ...A10 Thunder Series 930 Installation Guide Power On Document No TH 930 001 1 26 2015 page 14...
Page 43: ...page 43 Document No TH 930 001 1 26 2015 A10 Thunder Series 930 Installation Guide...
