OPERATION:
1. Loosen the two shipping travel knobs. (These are on
either side of the motor cover, below the head.)
2. Press the MOTOR switch to the “ON” position.
3. Fill the spinner head with the desired amount of sugar floss.
Never fill the head past the bottom level of the filler spout.
(Note: For best results, keep the spinner head full.)
4. Press the HEAT switch to the “ON” position.
5. Turn the HEAT CONTROL knob to heat setting HIGH.
6. Once floss starts to flow out of the head, reduce the HEAT
CONTROL to the green range as indicated on the METER.
(Note: Too high of a setting will cause cutting of the floss and
potentially clog the screen assembly.)
7. When the amount of floss that is being produced starts to
slow, add more sugar. DO NOT adjust the HEAT CONTROL
knob setting.
8. The typical operating setting on the HEAT CONTROL knob is
in the green range on the METER. This will vary due to
fluctuations in environmental situations.
**In case of a malfunction
IMMEDIATELY
shut-off the MOTOR
and
HEAT
switches and correct the problem.
COTTON CANDY
MACHINE
211 PEACH WAY, COLUMBIA, MO 65203 • 575.474.7881
|
323 MIDLAND DRIVE, JEFFERSON CITY, MO 65101 • 573.635.1516
WWW.A1PARTYFUN.COM • [email protected]
