5
4. WHEN FINISHED CLEANING TURN SWITCH OFF, PHOTO 4.
5. REMOVE THE PLUG FROM THE OUTLET AND TAKE VACUUM TO AN
OUTSIDE LOCATION AWAY FROM VALUABLES AND BREEZES (5).
6. RELEASE THE FLEXIBLE HOSE FROM THE AIR INTAKE DUCT. A
SMALL AMOUNT OF ASH MAY BE GENERATED SO TAKE CARE (6).
7. VERIFY ASH IS COLD! ALLOW TO COOL FURTHER IF NEEDED,
THEN DUMP DEBRIS. ASH IS A GREAT GARDEN SUPPLEMENT! (7)
D E F G
8. **EVERY 3 TO 5 USES CLEAN HEPA FILTER WHILE OUTSIDE AND
AWAY FROM VALUABLES. SCREW OFF THE FILTER WING NUT AND
REMOVE MESH COVER AND HEPA SEAL PLATE (NOT SHOWN). TAKE
THE FILTER OUT FOR CLEANING (SEE 9, BELOW) OR CHANGE.
Follow steps below from 1 to 3 for taking off the filter.
9.
CLEANING FILTER
- TO LIMIT DUST PLACE HEPA FILTER INSIDE
A PLASTIC BAG (not incl.). TO CLEAN FILTER TAP GENTLY AGAINST A
HARD SURFACE. EMPTY PLASTIC BAG AND INSPECT FILTER. DUST
WITHIN THE FILTER PLEATS MAY REQUIRE GENTLE FLEXING OF
THE FILTER BY SQUEEZING THE FILTER’S RUBBER SEALS SO AS TO
MAKE THE FILTER OVAL INSTEAD OF ROUND. TAP FILTER WHILE
“OUT OF ROUND” TO GET DEEPLY SET DUST OUT OF PLEATS.
Follow steps below from 4 to 7 for re-assembly of the filter
10.
IMPORTANT
- WITH FILTER INSTALLED AND LID IN PLACE
TURN VACUUM ON AT A DRY OUTSIDE LOCATION TO TEST FILTER
SEAL. LOOK FOR DUST AT THE EXHAUST PORT. A SMALL AMOUNT IS
NORMAL AFTER CLEANING FILTER. VACUUM UP A SMALL AMOUNT
OF ASH WHILE STILL OUTSIDE TO GIVE FINAL ASSURANCE OF A
GOOD SEAL AND TO VERIFY FILTER INTEGRITY. REPLACE FILTER IF
DUST PASSES THOUGH AT THIS POINT.
5
5
6
7
1
2
3
4
Note:
This process will be dusty.
Pictures depict clean machine
for illustative purposes.
!
4
5
6
7
Summary of Contents for Hearth Country 400
Page 1: ......