A-TS
44
https://a-ts.cn/en/
P3.14 is used to suppress the oscillation caused by the inverter and the
motor. If the inverter output current changes constantly at fixed load, the
oscillation can be reduced by adjusting P3.14.
7.5 Current vector control parameter ( P4 )
7.6 Multi-function terminal ( P5 )
The multi-function terminals can realize various functions. You may
assign functions to them by setting parameters P5.00~P5.04. Please
refer to table 7-3. Take X1~X3 for example in the following description.
Table 7-3
Setting
Functions
Setting
Functions
0
No function
1
Foreward run
2
Reverse run
3
MS frequency 1
4
MS frequency 2
5
MS frequency 3
6
External fault normally-open
input
7
External fault normally-closed
input
8
Reset signal
9
Forward jog
10
Reverse jog
11
Coast-to-stop input
12
Frequency increase ( UP )
13
Frequency decrease ( DN )
14
PLC operation pause
15
Acc/Dec prohibit
16
3-wire operation control
17
External interrupt signal
normally-open input
18
External interrupt signal
19
DC injection braking command
P3.14 Motor stabilization
factor
Range: 0
～
255
【
Depending on model
】
P4.00~P4.10 Reserved
Reserved
P5.00 Function of multi-function terminal X1
Range: 0
～
43
【
1
】
P5.01 Function of multi-function terminal X2
Range: 0
～
43
【
2
】
P5.02 Function of multi-function terminal X3
Range: 0
～
43
【
0
】
P5.03 Function of multi-function terminal X4
Range: 0
～
43
【
0
】
P5.04 Function of multi-function terminal X5
Range: 0
～
45
【
0
】
P5.05~P5.07 Reserved
Reserved
