A to Z Rubber Stamps RAPIDPRINT A Series, Manual

Page: 100 / 122

REPEAT SWITCH
RETROFITTING A STANDARD AN-E MACHINE
-Drill 1/2"DIA. hole in bottom casting-location specified on diagram.
-Apply Label p/n 00-05212-000000 onto casting using centerline to locate center of hole.
-Using an X-ACTO knife, cut off label material that is covering mounting hole.
-Attach 2 wire assemblies p/n 01-06930-001140 to Toggle Switch-one to the center terminal,
the other to the uppermost terminal.
-Remove Hex Nut & Knurled Nut from Toggle Switch. Thread Knurled Nut back onto shaft
of Switch. Insert Switch from inside of casting. Thread Hex Nut onto Switch and tighten
securely using an adjustable wrench. Caution is necessary to prevent scratching Label.
WIRING MACHINE
Wire machine per wiring diagram 08-00218-000001 and/or perform the following steps:
1-P.C. Bd must be D revision or later. If not, it must be replaced with p/n
01-07310-001129.
2-White solenoid wire must be moved from position 5 of connector to position 8.
3-Insert remaining ends of orange wires (p/n 01-06930-001140) in connector positions
5 & 10.
01/04/2012 100