7 DISASSEMBLY PROCEDURE
Pag. 33 di 37
7.3.1
Fork cylinder disassembly and reassembly
If it is necessary to replace the entire cylinder, reassemble everything following the
instructions listed in the previous point in reverse, if you also need to replace some cylinder
component, proceed as indicated below:
1.
Clamp the cylinder in a vice with rubber jaws, taking care not to deform the housing).
2.
Unscrew cap with a sector wrench.
3.
If you find it difficult to unscrew the cap, it is necessary to slightly heat the area of the thread
concerned to facilitate unscrewing.
4.
Unscrew the stem.
5.
Disassemble / separate the rest of the components and seals from each other (at this point
it will be easy and intuitive).
6.
Replacing the worn components, follow the previous steps in backwards, re-lock the cap
applying a medium strength thread locker.
7.
If there is a damaged seal, it is advisable to replace the entire kit.
8.
Picture 26