AR610
Always use two hands when operating a pressure washer. This will assure
complete control of the equipment.
Always test the GFCI plug prior to using the cleaner.
Never test the pressure of the cleaner against any part of the body.
Use the trigger lock whenever the spray gun is not being used for cleaning.
Always seek emergency medical care immediately if any fl uid penetrates the
skin. A cut may be deeper and more serious than it appears.
3. G
ENERAL
R
ULES
3.1.1
The USE and MAINTENANCE manual constitutes an essential
part of the cleaner equipment and should be kept in a safe place
for future reference. If you sell the cleaner, the manual should
be handed on to the new owner.
3.1.2
Before starting the cleaner, make sure that it is receiving water
correctly. Operating the cleaner without water could damage
the seals.
3.1.3
Do not disconnect the plug by pulling on the electrical cable.
3.1.4
If you are too far from the object you wish to clean, do not move
the cleaner nearer by pulling on the high pressure hose; use the
handle provided.
3.1.5
Protect the cleaner from freezing during the winter. Store in a
warm area.
3.1.6
Do not obstruct the ventilation grilles during operation.
3.1.7
The cross-section of any extension cord used must be
proportional to their length, i.e., the longer the extension
cord, the greater the cross-section; cables with a protection
level of “IPX5” must be used. See table A.
3.1.8
Position the cleaner AS NEAR AS POSSIBLE to the water
supply.
3.1.9
The packaging is easily recyclable, and must be disposed of
in compliance with the regulations in force in the country of
installation.
Table A
Voltage Volts
Extension cable
Extension cable
up to 25 m
up to 50m
Motor
220 – 230240
Section3x1.5mm
2
Section3x2.5mm
2
100 – 115120
Section3x2.5mm
2
Section3x4mm
2
