Clock Set
Temperature Setting
The clock is Real Time Clock. Press “Clock
Set” button for 3 seconds, the hour time
(first two digits) starts blinking. Adjust the
hour time by pressing
S
or
T
button and
press “Clock Set” button to set the hour time
and press “Clock Set” button again, the
minutes time (last two digits) starts blinking.
Adjust the minute time by pressing
S
or
T
button and press “Clock Set” button to set
the minute time. Now the clock time is set as
shown in (Fig. 23).
Press the
S
or
T
button until the required
temperature is displayed on the LED
display. Wait for few seconds without
pressing any buttons, the value flashing in
the LED display will be changed as set
temperature and stored in memory. It will
return to its normal mode and the heating
of the water is based on the new set
temperature. While setting, the LED display
glows as shown in (Fig. 24).
Figure 23
Figure 24
You can know the time by pressing the “Clock Set” button in power on mode. The time will
display for ten seconds, then return to temperature display mode as shown in (Fig. 22).
NOTICE
The clock time to be set before setting the Timing mode.
Default set temperature (factory setting) is 70°C.
NOTICE
14
or
or
3 sec
or
or
Summary of Contents for CEWHR 35
Page 27: ......
