A.O. Smith BFC Cyclone 120, Installation, User And Service Manual

Page: 48 / 118

Caution
The anode protection remains active when the water heater is in OFF mode and the
control switch is set to 0.
Note
Any leakage from the tank and/or connections can cause damage to the immediate
environment or floors below the level of the boiler room. Install the water heater above a
waste water drain or in a suitable metal leak tray.
The leak tray must have an appropriate waste water drain and must be at least 5 cm
deep with a length and width at least 5 cm greater than the water heater.
6.2 Instructions on the water heater
The water heater has some safety instructions on its cover:
The text "Read the installation instructions before installing the appliance".
The text "Read the user instructions before putting the appliance into operation".
Also the packaging has some safety instructions:
The text "Read the installation instructions before installing the appliance".
The text "Read the user instructions before putting the appliance into operation".
The text "The appliance may only be installed in a room that meets the required
ventilation regulations".
Some safety pictograms:
CE approved
this way up
fragile
keep dry
maximum stacking height is 1
(BFC 80, 100 and 120)
2
maximum stacking height is 2
(BFC 28, 30, 50 and 60)
n
•
•
•
•
•
•
48 Installation, Maintenance and Service part