NEED HELP? GIVE US A CALL
877.333.7108
INSTALLATION GUIDE
2
1
2
3
4
Lightly place system head onto cartridge
(do not fully attach) to determine a suitable area
under the sink to mount the system vertically.
After marking placement for
mounting screws, use a 7/32" drill
bit to drill holes. Carefully tap plastic
anchors into the holes with a hammer.
Place the mounting screws into the
anchors and mount the system head
to the wall.
Three (3) inches of clearance from the base of the
cartridge is needed for easy cartridge replacement.
The system head must be installed less than three
(3) feet from the COLD-water inlet valve.
System Head Mounting Options
Fully connect cartridge to system head by
pushing in and turning the cartridge to
the right until it locks into place.
1
1
2
2
Option 1
Measure the distance between
mounting holes on back of system
head. Use this measurement to
determine placement of mounting
holes and mark with a pencil.
Note: make sure mounting holes are level.
Note: Remove system head before
proceeding to step 3.
Option 2
Remove the cover from the system head as
shown below (1). With cover removed, place
system head in desired location. Use a pencil
to mark placement of screws (2). Place cover
back on.
1
2
3
3"
Summary of Contents for 1449244
Page 1: ......
