17
ASCII Command
r ip mode!
Get network IP mode
IP mode: Static
s ip addr xxx.xxx.xxx.
xxx!
Set network IP address
Set IP address:192.168.1.100. Please
use “s netreboot!” command or
repower device to apply new config!
DHCP on, Device can’t config static
address, set DHCP off first.
r ip addr!
Get network IP address
IP address:192.168.1.100
s subnet xxx.xxx.xxx.
xxx!
Set network subnet mask
Set subnet Mask:255.255.255.0.
Please use “s net reboot!” command
or repower device to apply new config!
DHCP on, Device can’t config subnet
mask, set DHCP off first.
r subnet!
Get network subnet mask
Subnet Mask:255.255.255.0
s gateway xxx.xxx.xxx.
xxx!
Set network gateway
Set gateway:192.168.1.1 Please use
“s net reboot!” command or repower
device to apply new config! DHCP
on, Device can’t config gateway, set
DHCP off first.
r gateway!
Get network gateway
Gateway:192.168.1.1
s tcp/ip port x!
Set network TCP/IP port (x=1~65535)
Set tcp/ip port: 8000
r tcp/ip port!
Get network TCP/IP port
tcp/ip port: 8000
s telnet port x!
Set network telnet port (x=1~65535)
Set telnet port: 23
r telnet port!
Get network telnet port
telnet port: 23
s net reboot!
Reboot network modules
Network reboot…
IP Mode: Static
IP: 192.168.1.72
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Mac address: 00:1C:91:03:80:01
CONTROL SETTING
s autopower z!
Set display auto power on/off control z=0~1 (z=0 disable, z=1
enable)
Display autopower control enable
r autopower!
Get display auto power state
Display autopower control enable
s autopower mode z!
Set display auto power control mode z=1~3 (z=1 RS-232, z=2
CEC, z=3 IR)
Display autopower control by RS-232
r autopower mode!
Get display auto power mode
Display autopower control by RS-232
s autopower on time y!
Set auto power on timeout y=0~600 seconds
Display autopower on timeout is 100
seconds
r autopower on time!
Get auto power on timeout
Display autopower on timeout is 100
seconds
s autopower off time y!
Set auto power off timeout y=0~600 seconds
Display autopower off timeout is 100
seconds
r autopower off time!
Get auto power off timeout
Display autopower off timeout is 100
seconds
s cec cmd (PORT)
(
DESTINATION)
(OPCODE)(ARGS)
end!
CEC command sending. (PORT) is 1 byte; [PORT] = 01~02 is
hdmi output 1~2; (DESTINATION) is 1 byte, 4~7bit is
[SOURCE], 0~3bit is [DESTINATION] [SOURCE] is command
Initiator LogicAddress, [DESTINATION] is command Follower
LogicAddress. [OPCODE] is Operating code for CEC, [ARGS]
is the parameters for the CEC opcode, Some of the CEC
commands have parameters and some have no parameters, so
[ARGS] is Optional end! Is the terminator
PORT: HDMI OUT 1
SOURCE: 05
DESTINATION: 0F
OPCODE: 82
ARGS: 10 00
A
NEU
VIDEO
