SecuGuard Basic
2. Playback
83
Add:
Click the “Add” button then drag a rectangle area where you want to
check. The search area will overlay a transparent red mask.
Delete:
Define a rectangle area on the image first, then click “Delete” button to
remove the region that was defined.
Default: Click the “Default” button to select full image for motion detection.
Check the “Show Search Image” to display the searching video sequence or un-check this
box to only show the image once the event found.
Check the “Show Detect Mark” to display the detect result on the image by pink
rectangles.
Select the “Sensitivity” to define the sensitivity of detection. The higher value means the
event will be triggered easier.
Select the “Detect Interval” to define the interval of motion detection. If set longer value,
means system will use less CPU computing power to check motion detection.
When the event has been triggered, the window on the right side will display the
triggered image. If the event is not matched your expectation, click the “Continue” button
to search next event.
If you found the matched event, click the “OK” button to return to the playback panel,
and all playing channels will be synchronized to the same timestamp of the event.
Click Cancel button to abort this smart search job.
