A-iPower PWF3400KV, Owner'S Manual And Operating Instructions

Page: 12 / 80

SET UP 10
Assembly
1. Slide the handle assembly into the open
ends of the frame, and then insert screw
through the holes in the handle and the
pressure washer frame, place washers
and nut onto screw and tighten securely.
See Figure A.
Figure A
2. Attach the gun holder assembly to the
frame, install the lock nut, wrench tighten
until the nut is snug. (Rotate the holder
according to the need.)
See Figure B.
Figure B
3. Insert the hose holder into the holes on
the back of panel.
See Figure C.
Figure C
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
4. Connect the pressure hose to the pump
outlet fitting and tighten the nut firmly by
hand, DO NOT use any tool to tighten.
See Figure D .
Figure D
5. Connect the pressure hose to the
handle of the spray gun and tighten the
nut firmly by hand.
See Figure E.
Figure E
6. Remove the protective cap on the wand
Wand
Spray gun tip
inlet. Insert the wand into the spray gun
tip and tighten the nut firmly by hand.
See Figure F.
Figure F