A-iPower PWE1801, Owner'S Manual And Operating Instructions

Page: 12 / 87

SETUP 10
Assembly
Figure A-1
Figure A-2
Figure C
Figure D
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
1. Insert the male end (A) of the wand into the female
bayonet outlet (B) firmly.See Figure A-1.
2. Connect the high pressure hose to the pressure
washer gun assembly by turning the fitting clockwise.
Ensure the fitting is fully tightened to the pressure
washer gun.See Figure B.
3. Insert the male end of the bottle into the female outlet
on the trigger handle. (See Figure C).
4.While pushing in the bottle firmly, tum clockwise until
tabs lock into place to ensure a leak-free connection.
(See Figure D)
Unscrew the bottle from the assembly and fill with
pressure washer detergents/soaps only.
NOTE: For easier installation of the hose to the unit
or trigger it is suggerted to add pressure washer or
dish detergent to the rubber seal at each end of the
hose. This will allow for easier installation and a snug
fit.
While pushing in the wand firmly,turn clockwise until
tabs lock into place to ensure a leak-free connection.
See figure A-2.
Figure B
Inlet Coupler
Collar
High Pressure Hose