Operating and Assembly Instructions – A.B.S. Flexilo MODUL for wood pellets
Assembly
Subject to technical change
Issue 09/2016
Page 29 of 36
©A.B.S. Silo- und Förderanlagen GmbH
HP-M
HP-M4R
HP-M3R
HP-M6R
5.8.2 Connection Modul to Modul
After you have bolted the suction probes to the modules, arrange them in the order intended
for your silo.
Possible module arrangements
After you have arranged the modules in the right order, bolt them together. For this use the
M8x16 bolts + washers and M8 stop nuts.
Once this has been done, push the clamping bars with bolts through the holes outwards.
Then pull the silo sack over them and guide the holes of the silo sack over the bolts. Now,
from the outside, place the clamping bars with holes over the bolts. Be sure to use the angle
clamping bars at the corners.
HINT: Start at the corners.
First the clamping bar with the bolts on
the one side, then align the angle clamping bar and
then push the second clamping bar with bolts
against it on the other side. For this it is best to put
your hand into the silo through the middle and to
push the clamping bar with bolts outwards.
Please note: For frame heights of >2.00 m the modules
are bolted together using the clamping bars with bolts for
additional stability.
See picture
Put the modules on a pallet or something similar
before connecting them to the silo.
See picture
