background image

NET+ Instagrid 230 V-PowerPack  

 

QUICK GUIDE 
 

 

 

v.1.0 

After 10 seconds have elapsed, the LED indicator 

[5]

 will go out. Next, remove the charging cable 

and set the rotary switch 

[3]

 either to   (to activate the transport mode) or to   (to operate a 

connected device). 
Note: No charging below 0 °C. 

 

4.2 

TRANSPORT MODE 

Set the rotary switch 

[3]

 to   (turn anticlockwise) to activate the transport mode. 

The  NET+  Instagrid  230  V-PowerPack  can  now  be  brought  to  the  desired 
location. Use the transport mode for any type of transport. 

 

4.3 

DISCHARGING 

Deactivate  the  standby  mode  and  activate  the  operating  mode  by  turning  the 
rotary switch 

[3]

 from   to   (turn clockwise). While the LEDs 

[5]

 light up in the 

start-up sequence, the device will 
perform  an  initial  self-test.  If  the 
LEDs 

[5]

 go out after the start-up 

sequence, 

the 

device 

is 

completely  discharged  and  must 
first  be  charged  (

see  section  4.1 

CHARGING

). 

 
If  one  or  more  LEDs 

[5]

  light  up 

green  after  the  start-up  sequence,  the  device  is  ready  for  operation  via  the  outputs

  [4  |  9]

Equipment can now be connected to either one of the two outputs 

[4 | 9]

. During operation, the 

number  of  green  LEDs 

[5]

  indicates  the  current  state  of  charge.  Regularly  check  the  state  of 

charge during operation. If the device is almost completely discharged, the LED on the far left will 
flash  green.  The  device  should  then  be  recharged  as  soon  as  possible  (

see  section  4.1 

CHARGING

). After operation, set the device to standby mode by turning the rotary switch 

[3]

 to 

 (

see section 4.1 CHARGING

), or activate the transport mode by turning the rotary switch 

[3]

 to 

 (

see section 4.2 TRANSPORT MODE

). 

 
5. 

STORAGE 

Store the device in transport mode and without any connected cables or equipment.  
Do not store the device in a discharged state for longer periods of time. This may cause deep 
discharge of the device, requiring it to be recommissioned by the manufacturer. 
Charge the device at least once every three months. For a long service life, store the device at 
temperatures between 0 and 23 °C in a low-humidity environment. 
 

Reviews: