9
SPI & SPP MANUAL
VER. 2 REV. 0
Technical specifications
SPI MODULE
Product code
SPI
ELECTRICAL SPECIFICATIONS
Operating voltage [V]
Clamps: +/- 10 to 60 AC/DC
Main power connector
2 x cable terminals 2 x 1.31 mm
2
Active protection
Against polarity inversion on both power connectors
Self-consumption power [W]
< 1.5
Typical current per port [A] (*)
0.7
GND connector
Screw M4
LED indicator
Status
Peak current protection [kA]
15
Overvoltage protection [V]
150
Protection mode
All the lines (1-8) Protected (L-L) and (L-G)
SPD technology
2 phases: TVS and GDT
NETWORK SPECIFICATIONS
Ethernet connector
2 x Jack RJ45 shielded (LAN / PoE + Data)
Network transmission speed
10BaseT; 100BaseT; 1000BaseT
MECHANICAL SPECIFICATIONS
Dimensions (LxPxH) [mm]
87 x 84 x 24 (36 with flange)
Weight [gr]
200
Material
Varnished iron
Mounting
On rack (with optional Rack bracket) or Din rail (with optional Din clip)
ENVIRONMENTAL SPECIFICATIONS
Operating ambient temperature [° C]
-20 to +45
Operating humidity without condensation [%]
5 to 95
IMPORTANT NOTES
:
•
(*) Although the typical value indicates that 0.7A current can flow continuously and indefinitely, this value must not
be exceeded.
•
(*) The typical current of 0.7A per port can be reached if the PoE configuration chosen to power a device is MODE A
+ B because it uses all four pairs of conductors for power supply
2
. If it is MODE A or MODE B, the typical current per
port will be 0.35A.
2
See the section “Selectors”