12
6. Start the motor by depressing the lock-off button (5) and
squeezing the trigger switch (4).
7. Always let the blade reach full speed (approximately
2 seconds) before you begin to cut into the work piece.
8. Slowly push the saw forward using both hands, keeping
the red laser light beam on the line of cut.
9. After completing your cut, release the trigger switch
and allow the blade to come to a complete stop.
Do not remove the saw from the work piece while
the blade is moving.
10. Switch off the laser beam on completion of the cut.
Note.
The laser generated line is preset to align with the
left side of the blade (closest to the motor).
Changing the blade
CAUTION.
Always ensure that the saw is switched off
and unplugged from the power supply before making any
adjustments.
1. Place saw on its side on a flat surface.
2. Rotate the saw blade by hand whilst depressing the
spindle lock button (20) until the blade locks (Fig. Q).
3. Whilst depressing the spindle lock button, turn the blade
bolt anti-clockwise using the wrench provided (Fig. R).
4. Remove the outer blade flange and the blade bolt.
5. Raise the lower blade guard (14) using the blade
guard lever (13).
6. Remove the saw blade
from the inner flange
and pull it out (Fig. S)
7. Clean the saw blade
flanges thoroughly
before mounting the new
saw blade. Wipe a drop
of oil onto the inner and
outer flange where they
will touch the blade.
8. Mount the new saw blade onto
the spindle and against the
inner flange.
9. Replace the outer flange and
tighten the blade bolt (Fig. T).
WARNING.
The direction in
which the blade rotates has
to be the same as the direction
of the arrow marked on the housing (25).
10. Ensure that the spindle lock button (20) is released.
11. Before using the saw again, check that the safety
devices are in good working order.
IMPORTANT.
After replacing the saw blade, make sure that
the saw blade runs freely by turning the blade by hand.
12. Plug the machine into a power socket and run the saw
under no load to check that it runs smoothly before
using it to cut any material.
Adjusting the twin laser
IMPORTANT.
The tool should be plugged into a power
source when checking and adjusting the dual laser line.
Ensure hands are kept well away
from the saw blade and avoid
accidental activation of the trigger.
1. To adjust the twin laser, insert
a hex key into the laser guard
and turn to move the laser
from side to side. This will
align the laser with the blade
(Fig. U).
R
Q
S
T
U
