8i 210820, Instructions Manual

Page: 29 / 32

Programming MEMORY positions
• You can store 2 positions of the bed in the memory using the M1 and M2
keys.
•
Put the bed in a position you want to store.
• Press programming key
D
until the blue LED at the top lights up brightly (after
3 sec.).
• Now press M1 or M2 to store the current position.
•
The white LED on the motor and the backlight of the remote control flashes 2
times. The position was stored.
PROBLEM CASE: Reset of the receiver (factory settings)
If problems occur during the installation of the motor and the remote controls you may
reset the receiver and repeat the connecting procedure:
•
Press 4 x the connecting button A of the motor until the white LED light goes
on, afterwards please press a
5th
time.
• The white LED flashes 2 x and will go out. The receiver went back to the
original factory settings.
•
Do this for both motors
•
The connecting procedure between remote and receiver can now be executed
as described above.
**synchro
A.
LED +
knop/boutton/button/Taste
1.
D.
2.
LED
** Only remove the cap cover when using the synchro cable!