6
Installation
1
Installing the electrostatic sticker.
Clean your rear windshield and put the
electrostatic sticker on the recommended
upper area of the windshield, as shown in the
figure below. Make sure you remove air
bubbles between the sticker and the glass.
2
Installing the rear camera.
Peel off the protective film from the adhesive
sticker on the base of the mount, and paste the
rear camera onto the electrostatic sticker in
the dotted area.
3
Connecting the power supply.
Connect the rear camera with the rear signal
wire (connect ports A and B together). As
shown in the figure on the left, run the wire
along the top of the rear windshield, C-pillar,
top of the side windows to the main device.
Plug the Mini USB 8pin power port into the
main device (the AV/IN port of the main
device).
4
Adjust the dash cam angle.
Turn on the main device and switch to rear
camera recording mode. Adjust the camera
angle based on the preview screen to ensure
that the camera is facing the back of the
vehicle.
Note: The installation and wiring methods for
different vehicles may differ from what
described in the user manual. The installation
shall be conducted by a professional installer.
