5
Installation
1
Installing the electrostatic sticker.
Clean your windshield and put the electrostatic
sticker on the recommended area as shown in
the figure. Make sure you remove air bubbles
between the sticker and the glass.
Note
: Make sure to stick the electrostatic sticker
on a flat and smooth part of the windshield,
press it firmly, and avoid sticking it on the edge of
the windshield’s film to prevent it from falling
down.
2
Installing the memory card.
Insert the memory card into the card slot with its
contacts facing down until you hear a click. The
memory card is installed.
3
Installing the mount.
Attach the mount into the slot and slide up, as
shown in the figure on the left. You will hear a
snap when it is in place. Make sure the mount is
securely installed to the dash cam.
4
Mounting the dash cam.
Peel off the protective film from the adhesive
sticker on the base of the mount, and paste the
dash cam onto the electrostatic sticker in the
dotted area.
5
Connecting the power supply.
As shown in the figure, run the power cord along
the top of the windshield, down the A-pillar, and
around the glove compartment, so that the
power connector is near the cigarette lighter.
Connect the power cord to the car charger, then
plug the charger into the cigarette lighter socket.
Notes
: Use the included crowbar to hide the
power cord underneath the vehicle’s headliner
and rubber seal along the A-pillar. Depending on
the vehicle, the cigarette lighter socket may be
located in a different position. The figure on the
left is for reference only.
6
Adjust the dash cam angle.
Turn on the dash cam and adjust the camera
angle based on the preview screen to ensure that
the camera is facing the front of the vehicle.