5
Installation
1
Installing the electrostatic sticker.
Clean your windshield and put the electrostatic
sticker on the recommended area as shown in
the figure. Make sure you remove air bubbles
between the sticker and the glass.
Note
: Make sure to stick the electrostatic
sticker on a flat and smooth part of the
windshield, press it firmly, and avoid sticking it
on the edge of the windshield’s film to prevent
it from falling down.
2
Installing the memory card.
Insert the memory card into the card slot with
its contacts facing down until you hear a click.
The memory card is installed.
3
Pasting the dash cam.
Peel off the protective film from the heat
resistant adhesive and paste the dash cam
onto the electrostatic sticker in the dotted
area.
4
Connecting the power supply.
As shown in the figure, run the power cord
along the top of the windshield, down the A-
pillar, and around the glove compartment, so
that the power connector is near the cigarette
lighter. Connect the power cord to the car
charger, then plug the charger into the
cigarette lighter socket.
Notes
: Use the included crowbar to hide the
power cord underneath the vehicle’s headliner
and rubber seal along the A-pillar. Depending
on the vehicle, the cigarette lighter socket may
be located in a different position. The figure on
the left is for reference only.
5
Adjust the dash cam angle.
Turn on the dash cam and adjust the camera
angle based on the preview screen to ensure
that the camera is facing the front of the
vehicle.
