Wicher 508i
4
Wicher 508i Card Installation
Installation of the card should always be performed with the Amiga being powered down.
Wicher 508i
card has been designed for installation inside the Amiga 500/500+ computer.
After removing the original MC68000 CPU, one can start the proper
Wicher 508i
card installation. In order to carry it out,
the pins found at the bottom side of the card, should be carefully inserted into the U1 chip socket, and then the card
should be gently pressed, until it seats firmly.
As the next step, one should connect the two provided cables to the card’s SV1 port, following the instructions presented
below.
Lokalizacja gniazda SV1 znajduje się na poniższym obrazku.
The
INT2
signal of the SV1 port should be connected to the 21
st
pin of the U7 (ODD CIA A) chip, whereas the
OVR
signal of
the SV1 port should be connected to the 29
th
pin of the U5 (Gary) chip. Both of the aforementioned U7 and U5 chips
should be easy to locate on Amiga’s motherboard.
SV1 port location
