4Protect 3851, User Instruction Manual, Page: 10 / 18

EN
4Protect Workwear
ATTENTION: Read carefully before use!
USER INSTRUCTION MANUAL
article description available sizes
385x
DIN EN ISO 13688:2013 protective clothing
- General requirements
Declaration of conformity*: These garments Personal Protective are
Equipment (PPE). marked by the CE-label, as the PPE They are
complies with the requirments of the EU-Regulation 2016/425 (and
following amendments) implemented by issuing within the Official
Register of the European Union by March 9th, 2016 relevant to
Personal Protective Equipment. Moreover, these garments comply
with the requirements of the European Technical Standards:
Source of Information: Beuth-Verlag GmbH, 10787 Berlin,
www.beuth.de.
(*The complete declaration of conformity, you can find at:
www.big-arbeitsschutz.de)
10
DIN EN 14404:2010 kneeprotection (in combination with kneepad
art. 8400) - Knee protectors for work in the kneeling position / type 2 /
performance level 1
4Protect workwear
trousers COLORADO
Identification and selection: The selection of suitable garments
must be made, based on the specific workplace requirements, the
type of hazards and the relevant environmental conditions. The
employer is responsible for the identification and selection of the
suitable and adequate PPE. Therefore, it is opportune to verify the
suitability of this garment to your requirements before use.
- mechanical hazards (protection can be provided in combination
- thermal hazards
- chemical hazards
- caught-in hazards in presence of moving parts
- fire crossing and extinguishing hazards
Furthermore this garment performance against skin damage caused
by solar radiation in the way to provide UV-A and UV-B sun
protection. Only covered areas of the body are protected by the
clothing. The measured UPF (UV Protection Factor) is > 50 and thus
offers a very high level of protection. The protection offered by this
PPE can be reduced by continuous use, in the case of expanding or
in wet condition.
This PPE offers no protection from:
with knee-pad article no. 8400)
- all hazards, different from the above specified
PPE category II:
Intended use:
This garment is suitable to offer protection against
hardware, lying on floor, as well as prevent chronically disease (e.g.
bursitis or cartilage-defect). Already existing disease cannot be cured
by wearing this knee-protection, but hurtful effects can be limited.
Important premise for the attainment of this aim is the combination of
knee-protection with proper work-wear, equipped with appropriated
kneepad-pockets which are made for this kind of purpose.
11
44 - 62,
24 - 30 (short-sizes)
90 - 110 (long-sizes)
EN 13758-2:2003+A1:2006 Textiles
- Solar UV protective properties
Field of application, uses & risk assessment: It is emphasised,
that the actual application conditions can not be simulated and it is
therefore the sole decision of the user whether the garment is suitable
for the intended application or not. The manufacturer is not
responsible for improper use of the product. Before the garment is put
into service, an assessment of the residual risk should be taken in
order to determine whether the garment is fit for the intended use.