Bus Board (4ms Bus Stick or other passive distribution board)
Any passive power distribution board can be used with the
Row Power 25
. If the bus board connects
to the power supply with a standard 16-pin Eurorack power cable, then simply use the male pin power
connector on the back of the
Row Power 25
to connect to the bus board. Verify the red stripe is
pointed down on both ends of the cable. An example using the 4ms Bus Stick is shown below.
The Bus Stick can be secured to the case using the adhesive pads on the back. Make sure the surface
is clean and apply pressure for 20 seconds. It’s safe to daisy-chain a flying bus cable or another Bus
Stick, but to insure the lowest noise system, use as few connectors as possible.
Solder connectors
The
Row Power 25
has a set of four holes for +12V, -12V, +5V, and ground. The holes are
0.082” (2.1mm) in diameter and are spaced 0.156” (3.96mm). They fit the Molex MTA156 connector
(example: Molex PN: 5273-04A or 09652048). They also will fit 14 AWG wire.
These connectors are provided for advanced users with sufficient knowledge of soldering and power
systems. They can be used with a custom or specialized low-noise bus board system. While 4ms
Company will warranty and support the internal circuitry of the
Row Power 25
, we do not offer
support for 3rd party or DIY bus boards or distribution systems.
Page of
3
4
Summary of Contents for Row Power 25
Page 4: ...Page of 4 4 ...
