Electrical and Mechanical Specifications
• 6HP Eurorack format module
• 0.95” (24mm) maximum depth (includes power cable)
• 10-pin Eurorack power header
•
Power consumption
•
Maximum values:
All output jacks shorted to ground, 22Vpp signal on all input jacks, knobs at 100%
•
+12V: 62mA
•
-12V: 55mA
• Line to Mod section (top)
•
Output: 1k impedance
•
Input: 100k impedance
•
Frequency Response: +/-0.1dB max deviation, 20Hz – 20kHz
•
Maximum output level: 22V peak-to-peak
•
Maximum gain: +30dB
•
Channel cross-talk:
Test conditions: Test signal input into left Line In jack. Sine wave at frequencies from 20Hz to
20kHz tested. Gain adjusted to maximum value without clipping. Result given as a ratio of the
appearance of test frequency measured on right Mod Out jack to left Mod Out jack. Test repeated
with left and right jacks swapped. Worst-case results for any channel and frequency reported. Note:
cross-talk is much higher when clipping occurs.
•
@1kHz: <-110dB
•
@10kHz: -78dB
•
@20kHz: -74dB
• Mod to Line section (bottom)
•
Output: 68 impedance
•
Input: 100k impedance
•
Frequency Response: +/-0.1dB max deviation, 20Hz – 20kHz
•
Maximum output level: 22V peak-to-peak
•
Maximum gain: 0dB (unity)
•
Channel cross-talk:
Test conditions: Test signal input into left Mod In jack. Sine wave at frequencies from 20Hz to
20kHz tested. Result given as a ratio of the appearance of test frequency measured on right Line
Out jack to left Line Out jack. Test repeated with left and right jacks swapped. Worst-case results
for any channel and frequency reported.
•
20Hz – 20kHz: <-110dB
Page of
4
4
